Transducer Shield FFS Beast Garmin LVS34 XDCR Forward Facing Sonar Bracket

Transducer Shield FFS Beast Garmin LVS34 XDCR Forward Facing Sonar Bracket - FFS BEAST’S sleek design is built of high-quality aluminum alloy & black cerakoted to provide a robust shield against the elements. The FFS BEAST  is configured of two rotating brackets held together with a 3/8 bolt. The precise “interlocking teeth” design allows you to rotate your Forward-Facing Sonar in 10-degree increments to your desired sweet spot and then tighten the knob to lock the BEAST in place.  Spring Back Bracket is attached to the FFS BEAST to safeguard the transducer from submerged objects by pivoting up and automatically returning to normal position once force is released, which helps protect the transducer from underwater obstruction.

Note: to install the FFS-Beast on the transom, there must be approximately 12in clearance from the Jack Plate in order to rotate the transducer – for example Skeeter ZX or Ranger 500 series are not a good candidate.

• Rotate the BEAST anywhere between -90 to +90 degrees
• Change the angle orientation by pivoting the Forward-Facing factory bracket
• Backing Plate is 1/4in thick high-quality aluminum alloy
• Black powder coated
• 6 pre-drilled holes to simplify installation of the FFS BEAST to the transom wall of your boat
• Wedge is black polyethylene and designed to put the transducer at the correct angle when the boat is in the water
• Stainless Steel Spring Back Bracket with two double torsion springs
• Axle Assembling Tool which is threaded on one end and used to remove and reassemble the axle and spring, if necessary
• Stainless Steel two prong Fork which is used to keep the SBB-5 top and bottom bracket together when disassembling and reassembling the axle and springs, if it becomes necessary to take the assembly apart